N500 INSTRUCTION MANUAL Explanation of Function Expanded Function mode Expanded Function mode Expanded Function mode Expanded Function mode (B (B (B (B-Group) Group) Group) Group) 2-10 A54 Motor input voltage setting AVR V Sel 0~5 (380V, 400V, 415V, 440V, 460V, 480V) 3 X O 2-33 Function Setting Read/ Function name Setting range Initial data Page code on rum Copy Second acceleration and deceleration function A55 2nd acceleration setting Acc Time2 0.1~3600.0Sec 0015.0sec O O 2-34 A56 2nd deceleration time setting Dec Time2 0.1~3600.0Sec 0015.0sec O O 2-34 A57 2nd stage adjustable selection 2nd F Mode _ 0~1 (TM,A Code) _ 0 X O 2-34 A58 2nd Acceleration frequency 2nd Acc F _ 0.00~A04 Hz 000.00Hz X O 2-34 A59 2nd deceleration frequency 2nd Dec F _ 0.00~A04 Hz 000.00Hz X O 2-34 Accel-decel pattern A60 Acceleration curve selection Acc Curve 0~3 (Line,S curv,U-curv,RU-curv) _ 0 X O 2-35 A61 Deceleration curve setting Dec Curve 0~3 (Line,S curv,U-curv,RU-curv) _ 0 X O 2-35 Function Setting Read/ Function name Setting range Initial data Page code on run Copy Restar mode B01 Selection of restart mode IPS Mode 0~3 (ALM, FTP, RST, ZST) 0 X O 2-36 B02 Allow under-voltage power failure time(IPS Time) 0.3~1.0Sec 0001.0sec X O 2-36 B03 Retry wait time IPS Wait 0.3~100.0Sec 0001.0sec X O 2-36 Electronic thermal B04 Electronic thermal level setting E Thm Set _ 20.0~120.0% 0100.0% X O 2-37 B05 Electronic thermal characteristic selection (E Thm Char) _ 0~1 (CRT, SUB) 0 X O 2-37 Overload Restriction B06 Overload restriction selection OLoad Mode 0~2 (All Off, A/F On, Fix-On) _ _ 0 X O 2-37 B07 Overload restriction level OL Lev Set _ 50.0~200.0% 0120.0% X O 2-37 B08 Overload restriction constant OL Val Set _ 0.1~30.0Sec 0001.0sec X O 2-37 Lo ck B09 Software lock mode selection SLock Mode 0~4 (SFT All, SFT Fset, All, Fset, Normal) _ _ 4 X O 2-39 Other Function B10 Start frequency setting Min F Set _ 0.10~10.00Hz 000.50Hz X O 2-39 B11 Carrier frequency setting Cary F Set _ 2.0~4.0kHz 0002.0KHz X O 2-39 B12 Initialization mode Init Mode 0~4 (NONE,TRIP, PARAM, TIME, All) 0 X O 2-40 B13 Initializatio data selection Init Data 0~3 (2800HF, 3500HF, 3200HFP, 3800HFP) 1 X O 2-40 B14 STOP key validity during terminal operation (Stop SW) 0~1 (OFF,ON) 0 X O 2-40