A NOTE ABOUT SAFETY GENERAL Any time you see this symbol in manuals, instructions and on the unit, be aware of the potential for personal injury. There are 3 levels of precaution : The high wall fan coil unit provides quiet, maximum comfort. In addition to cooling and/or heating, the high wall fan coil unit matched with an outdoor condensing unit filters and dehumidifies the air in the room to provide maximum comfort. IMPORTANT: The high wall fan coil unit should be installed by authorized personnel only; using approved tubing and accessories. If technical assistance, service or repair is needed, contact the installer.
The high wall fan coil unit can be set up and operated from the remote control (provided). If the remote is misplaced, the system can be operated from the “Auto” setting on the unit. 1. DANGER identifies the most serious hazards which will result in severe personal injury or death. 2. WARNING signifies hazards that could result in personal injury or death. 3. CAUTION is used to identify unsafe practices which could result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation. Operating Modes The high wall fan coil unit has five operating modes:
FAN Only AUTO HEATING (heat pumps only) COOLING DEHUMIDIFICATION WARNING PERSONAL INJURY, DEATH AND / OR PROPERTY DAMAGE HAZARD Failure to follow this warning could result in personal injury, death or property damage. FAN Only In the FAN Only mode, the system filters and circulates the room air without changing room air temperature. Improper installation, adjustment, alteration, service, maintenance, or use can cause explosion, fire, electrical shock, or other conditions which may cause personal injury or property damage. Consult a qualified installer, service agency, or your distributor or branch for information or assistance.
The qualified installer or service agency must use factory-authorized kits or accessories when modifying this product. AUTO In the AUTO mode, the system automatically cools or heats the room according to the user-selected set point. NOTE: AUTO mode is recommended for use on single zone applications ONLY. Using AUTO CHANGEOVER on multi- zone applications could set an indoor unit to STANDBY mode, indicated with two dashes (--) on the display, which will turn off the indoor unit until all the indoor units are in the same mode (COOLING or HEATING). HEATING is the system's priority mode. Simultaneous HEATING and COOLING is not allowed.
Read and follow all instructions and warnings, including labels shipped with or attached to unit before operating your new air conditioner. HEATING In the HEATING mode, the system heats and filters the room air. COOLING In the COOLING mode, the system cools, dries and filters the room air. DEHUMIDIFICATION (DRY) In the DEHUMIDIFICATION mode, the system dries, filters and slightly cools the room air temperature. This mode prioritizes air dehumidification but it does not take the place of a dehumidifier. Wireless Remote Control The remote control transmits commands to set up and operate the system. The control has a window display panel that displays the current system status.
The control can be secured to a surface when used with the mounting bracket provided. Wired Remote Control (Optional) Refer to the Wired Controller manual. 24V Interface (Optional) Allows the control of the Ductless System with a third party thermostat. Smartphone Control (Optional) Capability to be controlled by a smartphone. Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations. 2