REMOTE CONTROL BASIC REMOTE CONTROL OPERATION Before operation, ensure the unit is plugged in and power is available. CAUTION COOL Mode EQUIPMENT DAMAGE HAZARD Failure to follow this caution may result in equipment damage. Handle the control with care and avoid getting the control wet. IMPORTANT: The remote control can operate the unit from a distance of up to 26 ft. (8 m) as long as there are no obstructions. When the timer function is used, the remote control should be kept in the vicinity of the fan coil (within 26 ft. / 8 m). The remote control can perform the following basic functions:
Turn the system ON and OFF Select the operating mode Adjust room air temperature set point and fan speed Adjust right-left airflow direction 4 1 2 Refer to the “WIRELESS REMOTE CONTROL” on page 4 for a detailed description of all the capabilities of the remote control. 3 Swing Boost Clean Battery Installation Two AAA 1.5v alkaline batteries (included) are required for remote control operation. Fig. 4 — COOL Mode To install or replace batteries: 1. Press MODE to select the COOL mode. 2. Set your desired temperature using TEMP or TEMP . 3. Press FAN to select the fan speed in a range of Auto - ‘100%, 4. Press ON/OFF to start the unit. 1.
Slide the back cover off the control to open the battery compartment. 2. Insert the batteries. Follow the polarity markings inside the battery compartment. 3. Replace the battery compartment cover. Setting Temperature NOTES: The operating temperature range for units is 60-86°F (16-30°C)/(68-82 °F (20-28°C) (depends on model). You can increase or decrease the set temperature in 1°F(0.5°C) increments. 1. When replacing batteries, do not use old batteries or a different type battery. This may cause the remote control to malfunction. 2. If the remote is not going to be used for several weeks, remove the batteries. Otherwise, battery leakage may damage the remote control. 3.
The average battery life under normal use is about 6 months. 4. Replace the batteries when there is no audible beep from the indoor unit or if the Transmission Indicator fails to light. NOTE: When batteries are removed, the remote control erases all presets (e.g., COMFORTSENSE). The presets must be restored after the insertion of new batteries. Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations. 6