5. Tighten the fittings by hand until they are snug, and then tighten them an additional two-thirds of a turn with a pliers. Safety Instructions Features Operation Requirements Installation Instructions Washer Care Troubleshooting Washer Use Caution Do not overtighten the fittings or apply tape or sealant to the faucets or water supply intakes. This can damage the fittings. Make sure that the water supply hoses are not twisted or bent. A bent or twisted hose can leak and cause an electric shock due to the water leakage. To ensure the correct water usage, connect both hot and cold water faucets. lf either or both are not connected, an error code could occur. 6.
Turn on the hot and cold water supplies and check all the water supply intake connections and the faucets for water leaks. Connect the drain hose Caution Failure to slide the drain hose completely over the washer’s drain pipe may result in water leakage. Failure to move the clamp or hoop onto the washer’s drain pipe will result in water leakage. 1. Turn on the hot and cold water supplies and check all the water supply intake connections and the faucets for water leaks. 21