FOUR WIRE OUTLET If your outlet is a four-wire outlet, choose a 4- wire power supply cord with ring or spade terminals and UL listed strain relief. The 4 -wire power supply cord must: Bea t least 4 ft. (1.22 m) long. Have 10-gauge solid copper wires. four Match a four-wire receptacle of NEMA Type 14 -30R. The ground wire (ground conductor) may be either green or bare. The neutral conductor must be identified by a white color. Dryer Safety 4-Wire receptacle (14-30R) Operation Requirements Parts and Features 4-Wire system connections 1. Remove the center terminal block screw. 2. Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw. 3.
Connect the neutral wire (white or center wire) of the power cord and the appliance ground wire (white) under the center screw of the terminal block. Be sure to cross the screw through the ring of the power cord terminal and tighten the screw. Installation Instructions Dryer Use Appendix Dryer Care Troubleshooting 4. Connect the other wires to the outer terminal block screws. Be sure to cross the screw through the terminal ring and tighten the screw. 5. Tighten the strain relief screws. 6. Insert the tab of the terminal block cover into your dryer’s rear panel slot. Secure the cover with a screw. 4-wire system instructions: IMPORTANT: Ring-type terminals are recommended.
If using strap terminals, make sure they are tightened. A Center terminal block screw C Green or bare copper wire of the power cord D Neutral grounding wire (White) B External ground connector A E Neutral wire (white or center wire) B D E F F 3/4 " ( 1.9cm) UL-listed strain relief C 25