Downloaded from https://www.everyspec.com MIL-sTD-1312B f 1. SCOPE 1.1 Applicability. ‘l%isstandard establishes methods for testing fasteners, covering both the S1 and I-P units, to determine their physical and mechanical properties. These standard test methods will yield reproducible data for uae in research, development, procurement or product application. These teat methods shall be observed when specifically referenced in the applicable documents. In case of conflict between the provisions of these methods and the individual test procedure in the I I specification for a particular item, the latter shall take precedence.
This document exists as a dynamic standard subject to addition and change as reflected by the “state-of-the-art.“ 1 1- REFERENCED DOCUMENTS 2.1 Government documents. 2.1.1 Specifications, standards and handbooks. Unless otherwise specified, the following specifications, standards and handbooks of the issue listed in the current Department of Defense Index of Specifi- cations and Standards (DoDISS) and the supplement thereto (if applicable), form a part of this standard to the extent specified herein.
STANDARDS MILITARY MIL-sTD-962 Outline of Forms and Instructions for the Preparation of Military Standards and Military Handbooks 2.1.2 Documents applicable to a particular test method bookform standard part or section shall be listed therein. (Copies of specifications, standarda, handbooks, drawings, and publications required by contractors in connection with specific acquisition functions should be obtained from the contracting activity or as directed by the contracting officer.) 3. DEFINITIONS 3.1 S1 - The International System of Units (from the French Systeme International d ‘Unites”),as modified for use in the United States by the Secretary of Commerce.
Inch-pound units - Units based upon the yard and the pound commonly used in the United States of America and defined by the National Bureau of Standards. Note that units having the same names in other countries may differ in magnitude. 3.2 Definitions applicable to a particular test method bookform standard part or section shall be listed therein.