Downloaded from https://www.everyspec.com MIL-STD-31000A Elements “a” through “f” of section 5.3.3.1 a) All nonstandard, key and critical items that are non-graphical in nature shall be called out in a product definition. b) All nonstandard, key and critical dimensions shall be called out in the product definition. 5.3.3.3 Product drawings/models and associated lists. Product drawings/models and associated lists shall be prepared to provide the design, engineering, and manufacturing information necessary to enable the procurement or manufacture of an item essentially identical to the original item.
The product shall be defined to the extent necessary for a competent manufacturer to produce an item, which duplicates the physical, interface, and functional characteristics of the original product, without additional design engineering effort or recourse to the current design activity. Product data shall reflect the approved, tested and accepted configuration of the defined delivered item. This together with other TDP elements forms a Production Level TDP which will be used to support the product throughout its lifecycle. If 3D CAD Models are required they shall include the following information:
Elements “a” through “f” of section 5.3.3.1 a) All non-graphical requirements that are needed to unambiguously define the part shall be called out in the product definition. b) All dimensions needed to unambiguously define the product shall be called out in the product definition. 5.3.3.4 Commercial drawings/models and associated lists. Commercial drawings/models and associated lists provide engineering and technical information in support of end products, or designated portions thereof, which are commercially developed items, commercial off-the-shelf items (COTS), or items not developed at Government expense.
These data and lists shall be in accordance with the commercial design documentation practices of the contractor or supplier of the item. 5.3.3.4.1 Design disclosure. The degree of design disclosure on commercial drawings/models and associated lists, whether full design disclosure or limited design disclosure, shall be as stated in the contract or purchase order. 5.3.3.4.2 Data rights. Rights in data for commercial drawings/models and associated list shall be as stated in the contract or purchase order. 5.3.3.5 Special Inspection Equipment (SIE) drawings/models and associated lists.
SIE drawings/models and associated lists shall be prepared to provide the data required to manufacture or assemble SIE, which is mandatory to successfully produce the item. The SIE shall be defined in detail to the extent necessary for a competent manufacturer to manufacture or assemble SIE, which duplicates the performance characteristics of the original SIE. SIE is also known as special test equipment. 5.3.3.6 Special Tooling (ST) drawings/models and associated lists. ST drawings/models and associated lists shall be prepared to provide the data required to manufacture special tooling which is mandatory to successfully produce the item. The ST shall be defined in detail to the 16