U.S. Department of Defense MIL-STD-810C — MIL-STD-810C Environmental Test Methods Standard — PDF Manual Download (EN)

Downloaded from https://www.everyspec.com MIL-STD-810C 3.3.4.2 Determination of f. and fo.. The value of the locator frequencies, f. and fo., are as follows: Sinusoidal Surface (Figure 519.2-2 f. = 250 Hz f. = 200 Hz for items mounted on the aircraft skin High Frequency Random Surface (Figure S19.2-3) fo. = see Figure 519.2-11 Low Frequency Random Surface (Figure 519.2-4) f. = 300 Hz 3.3.4.3 Selection of fundamental gunfire frequency and the required harmonics. These properties shall be determined as follows:

, Set the gunfire rate, r, = fl and let f2 = 2f1, i?3,= 3f1 and f4 = 4f1 Note that the low frequency limit of the sine envelope of Gs (alsO the low frequency random envelop, Gr) shall be equal to fl - .2fl. The upper frequency limit of the sine envelope, only, shall extend to f4 + .2f4. 3.3.5 Multiple guns, dispersed. For configurations characterized by guns placed at separate stations as shown in figure 519.2-12, determine each D vector to the equipmentlocation’s;and from this obtain their corresponding Gs and Gr values and, finally, add each set of values to obtain the pre- dicted level.

3.3.6 Conversion of high frequency random spectrum, GZ The high frequency random spectrum may be readily converted to discrete,spectralvalues by multiplying G= by its corresponding 1/3 octave bandwidth. The bandwidth (Af) is determined by multiplying any given frequency (f) by .23. 3.3.7 Determination of overall RMS(OARMS). The overal1 RMS of the sine waves and the random noise spectrum is determined as follows: 1/2 OARMS = [Gsl + Gs2 + G~3 + Gs4 + O~sRl (8) where: G Gs2, Gs3, Gs4 = magnitude of sines (g2) OAMSR = overall mean squared g of spectrum (g2) the random noise 519.2-7 METHOD519.2 -.