Downloaded from https://www.everyspec.com 19 July 1983 I 11-3 UQ!mmEs 1 MIL-STD-810D 11-3.1 Pro edure I - En.gi.neerinu develon e.llk c m 1 Step 1. Mount test item in accordance with paragraph 11-2. I Step 2. Confirm’that the test item is operational. ~ ~ ! Step 3. Start test and teat to conditions specified in test plan developed as outlined in paragraph ?.-3.2:1. ,. ~ Step 4. Conduct test and monitor performance of test item againat failure I criteria. .2 I Step 5. Continue teat until malfunction occurs (see I-4-2). Step 6. Analyze failures and take corrective actions. .- Step 7. Document malfunctions per paragraph 11-4 and 1-4.3. Step 8.
Continue test until a suitable number of hours of environmental exposure have been achieved (see .1-3.3a). Step 9. Repeat steps 1 through 8 for each single stress or combination of stresses until all the stresses have been combined. Step 10. Document entire test per paragraph II-4. II-3.2 Prooedu re 11 - Flight/ODer&.lC2@ suDDOrt ta Step 1. Mount test item in accordance with paragraph II-2. Step 2. Confirm that test item ie operational. Step 3. Start teat cycle with a cold-day park simulation and continue the sequence aa ehown in table 520.O-IV. Step 4. Monitor test item performance throughout environmental exposure. ., Continue test until a test item malfunction occurs. Step 5.. Step 6.
knalyze and document malfunction per paragraph II-4 and I-4.3. z Continue test until a suitable number of hours’of ‘environmental :>. Step 7. exposure have occurred on at least one specimen (see Paragraph I-3.3b). I Step 8. Document entire test per paragraph II-4. ...? METHOD 520.0 19 July 1983 520.0-26