Downloaded from https://www.everyspec.com MIL-STD-610D 19 July 1983 Any interruption that results in more extreme reaufred by the eauivment specification should b. ~. exposure of the test item than be followed by a complete physical examination and operational cheek of the teat item (where possible) before any continuation of teatins. This iS especially true where a safety problem oould exist, suoh as with munitions. If a problem is diaoovered, the preferable c0ur96 of aotion is to stOP the test and start over with a new teat item. If this is not done and test item failure ocours during the remainder of ,thetest, the to the overteat condition.
If no problem is preinterruption conditions and continue from tolerance were exceeded. teat results oould be invalid due discovered, reestablish the point where the test II-2 FOR - 11-2.1 “@Q@,lac.c&; Before initiating any testing, from the test plan: . a. Determine the test temperature levels. b.. Determine the test item configuration. c. Determine the operational requirements. d. Estimate the time required at each temperature. (Install temperature sensors if necessary.) checkout at standard ambient conditions so that baseline data can be estab- lished. Munitions and other items, where applicable, shall alao be examined by nonrieatructiveexamination methods. Conduct the checkout as follows:
11-2.2 ~. All test items require a pretest o Steo 1. Stabilize the test item at stbdard ambient conditions (General Requirements, 4.4a),. Step 2. Conduot.a complete visual cial attention to stress areas such as between different Materials. ,. examination of the teat item with.spe- cornera of molded areas and interfaces Step 3. Document the resulta. Step 4. Prepare the test item in accordance with General Requirements, 4.5.2, and required teet item configuration. Step 5. teat plan. Conduct an operational”checkout in accordance with the approved Step 6. Record results for compliance with General Requirements, 4.5.1. Step 7. procedure 1.
If the teat item operates satisfactorily, proceed to step 1 of If not, resolve the problems and restart at step 1, above. 19 July 1983 503.2-11 METHOD 503.2