Introduction This manual is a guide for using the Mitsubishi Electric CNC. Supported models are as follows: Abbreviations in this manual are as follows: Be sure to keep this manual always at hand. Notes on Reading This Manual (1) This manual explains general parameters as viewed from the NC. For information about each machine tool, refer to manuals issued from the machine manufacturer. If the descriptions relating to "restrictions" and "allowable conditions" conflict between this manual and the machine manu- facturer's instruction manual, the later has priority over the former. (2) This manual is intended to contain as much descriptions as possible even about special operations.
The operations to which no reference is made in this manual should be considered impossible. CAUTION For items described as "Restrictions" or "Usable State" in this manual, the instruction manual issued by the machine tool builder takes precedence over this manual. Items not described in this manual must be interpreted as "not possible". This manual is written on the assumption that all the applicable functions are included. Some of them, however, may not be available for your NC system. Refer to the specifications issued by the machine tool builder before use. Refer to the Instruction Manual issued by each machine tool builder for details on each machine tool.
Some screens and functions may differ depending on the NC system (or its version), and some functions may not be pos- sible. Please confirm the specifications before use. To protect the availability, integrity and confidentiality of the NC system against cyber-attacks including unauthorized ac- cess, denial-of-service (DoS) (*1) attack, and computer virus from external sources via a network, take security measures such as firewall, VPN, and anti-virus software. (*1) Denial-of-service (DoS) refers to a type of cyber-attack that disrupts services by overloading the system or by exploiting a vulnerability of the system.
Mitsubishi Electric assumes no responsibility for any problems caused to the NC system by any type of cyber-attacks in- cluding DoS attack, unauthorized access and computer virus. In this manual, the following abbreviations might be used. L system: Lathe system M system: Machining center system MTB: Machine tool builder Also refer to the manuals on "Manual List" as necessary.
Supported models Abbreviations in this manual M800W Series M850W, M830W M800S Series M850S, M830S M80W Series M80W M80 Series M80 TypeA, M80 TypeB E80 Series E80 TypeA, E80 TypeB Abbreviations Supported models M800, M800 Series M800W Series/M800S Series M80, M80 Series M80W Series/M80 Series M800/M80, M800/M80 Series M800W Series/M800S Series/M80W Series/M80 Series M8, M8 Series M800W Series/M800S Series/M80W Series/M80 Series/E80 Series