Mount point change of installation frame from the rear to the front The upper and lower installation frames are attached on the inverter (one for each position). Change the mount point of the upper and lower installation frames from the rear to the front as shown in the figure. When reattaching the installation frames, make sure that the installation orientation is correct. Upper installation frame Lower installation frame Installation of the inverter on the enclosure Push the inverter heat sink part outside the enclosure, and fix the inverter to the panel with upper and lower installation frames.
Enclosure As the heat sink part protruded through the panel includes a cooling fan, this type of installation is not suitable for the environment of water drops, oil, mist, dust, etc. Be careful not to drop screws, dust etc. into the inverter and cooling fan section. 46 2. INSTALLATION AND WIRING 2.3 Installation of the inverter and enclosure design Shift Shift Inside the enclosure nverter Exhausted air There are finger guards behind the enclosure. Therefore, the thickness of the panel should be less than 10 mm (*1) and also do not place anything around finger guards to avoid contact with the finger guards.
Enclosure Installation frame Finger guard 10 mm*1 140 mm mm 6 Dimension of Cooling wind the outside of 185 mm the enclosure Coolin wind 185 mm NOTE