Руководство по эксплуатации Omron MS-9 Laser Scanner — Быстрый старт (EN)

Quick Start MS-9 Laser Scanner This guide is designed to get your scanner up and running quickly. When connected to a host computer with Windows™ operating system (2000 or above), you can use ESP (Easy Setup Program) to configure and control your MS-9 Laser Scanner . In addition to ESP , you can send commands to your scanner by serial command and by the scanner’s embedded menus. For a full explanation of the MS-9’s commands and features, refer to the Help section of ESP or contact your Microscan sales representative. P/N 83-210047 -04 Rev A 1

Стр. 1

Warranty For current warranty information, see: www.microscan.com/warranty . 2 MS-9 Laser Scanner Quick Start Guide

Стр. 2

Step 1 —Check Required Hardware Caution : If using your own power supply, be certain that it is wired correctly and supply voltage is 10 to 28VDC. Incorrect wiring or volt- age can cause software or equipment failures. • ( 1 ) MS-9 Laser Scanner , FIS- 0911-XXXXG • ( 2 ) A Host Computer • ( 3 ) Null Modem Configuration Cable , 61- 300026-01, DB- 25 Plug to DB-9 Socket, 6 foot. If using another host cable, be certain it does not have RTS/CTS connected to the host. • ( 4 ) IB-131 Interface Box , 99-400005-02 • ( 5 ) Power Supply , 97-100004-05 (120V), 97-100004-06 (240V) • ( 6 ) Object Detector (optional), 99-4400021-03    #$  $    !

"                     Hardware Required MS-9 Laser Scanner Quick Start Guide 3

Стр. 3

Step 2 —Connect the System Caution : Be certain all cables are connected BEFORE applying power. Always power down BEFORE disconnecting cables. 1. Connect the scanner ( 1 ) to the IB-131 Interface Box ( 4 ). 1 2. Connect the IB-131 ( 4 ) at the “HOST” 25- pin connector to the Host Computer ( 2 ) via a Null Modem Configuration Cable . 3. Connect the Power Supply ( 5 ) to the IB- 131 ’s “POWER” con- nector. 4. Apply power to the system.    #$  $    ! "                     Hardware Configuration 1. When wiring the IB-131 to a Host Computer that has a 25-pin connector, cross pins 2 and 3.

When wiring the IB-131 to a Host Computer that has a 9-pin connector, do NOT cross pins 2 and 3. 4 MS-9 Laser Scanner Quick Start Guide

Стр. 4