Before using for the first time en Note: Spare parts with a predeter- mined breaking point are not covered by our warranty obligations. A new disc holder is available from cus- tomer service under order number 00630760. Assembling the continuous feed shredder WARNING Risk of cutting! The cutting discs have sharp blades and edges. ▶ Only take hold of the cutting discs by the edge. ▶ Never touch the sharp blades and edges with bare hands. Before using for the first time Before using for the first time Prepare the base unit and the ac- cessories for use. WARNING Risk of injury! Improper use may cause injuries. ▶ Never assemble the accessories on the base unit. Preparing the base unit Note:
The food processor shown in the pictures may differ from your model in terms of shape and fea- tures. 1. Grip the disc holder level with the wings. → Fig. 8 The two plastic tips must point up. 2. Take hold of the required cutting disc by the edge and fit onto the disc holder with the side you re- quire facing up. 1. Set up the base unit as described in the main operating instructions. 2. Press the release button and raise the swivel arm until it engages. → Fig. 3 3. Place the bowl in the base unit. → Fig. 4 4. Turn the bowl anticlockwise until it engages. → Fig. 5 5. Press the release button and push the swivel arm down until it en- gages in position 1. → Fig. 6 6.
Press down the protective cover for drive 2 at the marking and remove. → Fig. 7 ‒ Fit single-sided discs with the blades or serrations facing up. ‒ Fit reversible slicing discs with the required marking facing up. → "Markings on the reversible slicing discs", Page 18 → Fig. 9 3. Insert the disc holder with the cut- ting disc into the housing. → Fig. 10 4. Place the lid on the housing. → Fig. Markings and must match up. 5. Rotate the lid clockwise until it en- gages. → Fig. 12 Markings and must match up. 19 11 gs