８ .Setting VNC for the NA ８ Setting VNC for the NA To publish the displayed NA screen, VNC server must be enabled. How to enable VNC server is described below. This setting can be made either by HMI Settings from the Sysmac Studio or from the Device System Menu of the NA. ８ - １ Setting with the Sysmac Studio Perform the following procedure to enables VNC function with the Sysmac Studio. 17 1. Select [Multiview Explorer]->[Configurations and Setup]->[ HMI Settings ] on the NA project. Double-click (or right-click-> Edit) to open the ”HMI Settings” table. Explorer]->[Configurations and Setup]->[ HMI Settings ] on the NA project.
Double-click (or right-click-> Edit) to open the ”HMI Settings” table. 2. Select the icon on the “HMI Settings” table. 3. Select [Use] for [VNC Server] and set as follows; VNC：Use Port No.：5900 (default) Mode：Choose from ”View Only” or “View and Operate”. Password：must be set (5 to 8 alphanumeric characters long) 4. Transfer the project to the NA.