7.3. Controller Setup Set up the Controller. 7.3.1. Hardware Settings Set the switches on the Serial Communications Unit. Precautions for Correct Use These hardware settings must be done with the power OFF. 20 1 Confirm that the power to the controller is OFF. * If the power is ON, you may not be able to proceed in subsequent operations according to the described procedures. Confirm the position of the physical switches on the front of the Serial Communications Unit according to the figure on the right. Check the position of the "Port 2" (RS-232C) connector, referring to the figure on the right. * Assumes the use of "Port 2" on the Serial Communication Unit. 2 Set the Unit. No.
switch to [0]. (The factory default unit number is "0") 3 Connect the Serial Communication Unit to the controller as shown on the right. PC Serial Communication Controller Unit Connect the Smart Camera cable to the Serial Communication Unit. USB cable End Cover Connect the controller to the PC by USB cable. Smart camera Power Supply Unit Special cable