5.2. Device Configuration The system components required for reproducing the connection procedures described in this document are as follows. NJ501-1300 CJ1W-SCU22 F430-F00M12M-SWA PC/ (Windows 10, with Sysmac Studio installed OS: Windows 10) RS-232C Cable (*1) RS-232C-I/O 2 Pronge cable V430-W2-3M Ethernet cable V430-WE-3M *1: The Ethernet cable is used for the connection to the PC running the AutoVision software. *2: Please refer to section 6.2 RS-232C Cable wiring diagram. Precautions for Correct Use Please prepare the latest file of "Sysmac Studio project file" from Omron Corp. beforehand.
(Contact Omron for information on how to obtain these files.) Precautions for Correct Use Use the Auto Update tool to update Sysmac Studio and CX-Protocol software to the version indicated in this document (or higher). If you use a version other than the version specified in this section, there may be differences in the procedures in Chapter 7 and after.
In this case, please refer to "Sysmac Studio Version 1 Operation Manual (W504)” or "CX-Protocol 6 I/O Cable V430-W8-3M DC24V USB cable Manufacturer Name Model Version OMRON NJ Series CPU Unit (Built-in EtherNet/IP Port) NJ501-1300 Ver.1.15 OMRON Power Supply Unit NJ-PA3001 OMRON Serial Communications Unit CJ1W-SCU22 Ver.2.1 OMRON Sysmac Studio SYSMAC-SE2□□□ Ver.1.29 OMRON Sysmac Studio Project File OMRON NJ F430 PMC _ _ _ R232C V100.smc2 Ver.1.00 OMRON CX-Protocol Project File _ OMRON NJ F430 PMC _ _ _ R V100.psw Ver.1.00 - Computer (OS:
Windows 10) _ - - USB cable (USB 2.0-compliant B-type connector) - OMRON Smart camera F430-F00M12M-SWA Ver.5.2.0 OMRON RS-232C-I/O 2 Pronge cable V430-W2-3M OMRON I/O cable V430-W8-3M OMRON Ethernet Cable (*1) V430-WE-3M RS-232C Cable (*2) DC24V Power Supply