Troubleshooting Solving Problems Audio Problems If sounds aren’t audible • Check that the volume is not muted. Pressing Fn+F7 toggles muting on and off. • Press Fn+UP-ARROW several times to make sure the volume isn’t set too low. • Check settings in BIOS Setup—from the System Devices menu, check that Audio is enabled. • Check for sound resource conflicts in BIOS Setup or Windows Device Manager. If sound doesn’t record • Check the playback or recording sound levels. • Check settings in BIOS Setup—from the System Devices menu, check that Audio is enabled. • Check software controls for recording sound (Sound Recorder under Program Accessories).
Display Problems If the OmniBook is on, but the screen is blank • Press the space bar to see if the computer is in Standby mode. • Press Fn+F1 or Fn+F2 to adjust the display. • Press Fn+F5 in case the internal display was disabled. (Do this three times to return to the state you started from.) • If the OmniBook is cold, allow it to warm up. If the screen is difficult to read • Check whether the display resolution is set to its default setting, 1024 Ч 768 (XGA). Check this in Start, Settings, Control Panel, Display, Settings. 8-4