Setting Up the OmniBook Configuring the OmniBook System Devices Menu Default 2-7 Parameters marked with * below appear only if the main parameter is Enabled (values specified by settings below). The list of parameters scrolls if it is longer than the screen. PS/2 Mouse Enables the PS/2 TouchPad and external PS/2 mouse, if present. Enabled External Fn Key Sets whether left-CTRL + left-ALT on an external keyboard is interpreted as the Fn key. Enabled IDE Controller Enables the primary (hard drive) and secondary (optional CD-ROM drive) controllers. Both FDD Controller Enables the floppy drive. Enabled Serial Port Sets how the serial port is configured:
by the BIOS (specified or automatic) or by a PnP operating system. Enabled Base I/O address* Sets the I/O address and interrupt. 3F8h, IRQ4 Infrared Port Sets how the infrared port is configured: by the BIOS (specified or automatic) or by a PnP operating system. Disabled Mode* Sets the hardware to support SIR (Standard IR), ASK IR, or FIR (Fast IR) infrared communications. (Driver installation required.) SIR Base I/O address* Sets the I/O address and interrupt. 2F8h, IRQ3 DMA channel* For Fast Ir mode, sets the DMA channel. DMA3 Parallel Port Sets how the parallel port is configured: by the BIOS (specified or automatic) or by a PnP operating system.
Enabled Mode* Sets the port to normal, bi-directional, EPP, or ECP. ECP Base I/O address* Sets the I/O address. 378h Interrupt* Sets the interrupt. IRQ7 DMA channel* For ECP mode, sets the DMA channel. DMA3