CAUTION The pressure plate is spring-loaded. Exercise caution when removing the pressure plate. Step 4 Use a small flatblade screwdriver to gently to detach the pressure plate retaining clips (callout 1). Step 5 Lift off the pressure plate. 21 Figure 87. Remove pressure plate Step 6 Lift the fuser-film heater assembly out of the assembly carriage. 21 Figure 88. Remove the fuser-film heater assembly Note When replacing the fuser-film heater assembly, verify that it is correctly oriented (callout 1). Position the end with the two-wire harness (black and white wire) is over the shaft end of the pressure roller. 118 Chapter 6 Removal and replacement C7058-90936