Remove tray 2 solenoid Step 1 Remove the following assemblies: • Remove the toner cartridge. See “Toner cartridge removal and replacement” on page 96. • If installed, remove tray 3. See “Remove tray 3” on page 97. • Remove the cassette from tray 2. See “Remove the cassette from tray 2” on page 97. • Remove the DIMM cover. See “Remove DIMM cover” on page 99. • Remove the rear cover. See “Remove rear cover” on page 100. • Remove the top cover. See “Remove top cover” on page 102. • Remove left cover. See “Remove left cover” on page 105. • Remove the EIO card. See “Remove EIO card” on page 98. • Remove the printer drive assembly. See “Remove printer drive assembly” on page 134.
• Remove the formatter PCB. See “Remove formatter PCB” on page 112. Step 2 Trace the two-pin solenoid wire harness and unplug it from the connector. Step 3 Remove the screw, as shown. Step 4 Lift out the tray 2 solenoid. 21 2 Figure 135. Remove the tray 2 solenoid 156 Chapter 6 Removal and replacement C7058-90936