Continuable, fatal, and accessory errors Additional information in the form of a secondary error message is available for each of the following three types of errors. The first entry in each of the following tables shows the primary error light pattern. The remaining entries illustrate the secondary error messages. The tables also contain information that typically appears in the status log area of the self test/configuration page. Table 28. Continuable attention error codes Table 29.
Continuable attention error secondary codes 184 Chapter 7 Troubleshooting C7058-90936 Control-panel light pattern Continuable attention error message Status log code Recommended action Continuable error or tray 1 is out of paper. Pressing GO causes the printer to attempt to recover from the error and print whatever it can. If the recovery is unsuccessful, the printer will return to the continuable error state. Press GO to attempt an error recovery and continue printing. If the error persists, press GO and JOB CANCEL simultaneously to view the secondary continuable error information. See table 29, “Continuable attention error secondary codes” on page 184.
Control-panel light pattern Continuable attention error secondary message Status log code Recommended action General continuable error Verify that all of the power-supply wire harness connections are connected correctly and fully seated. Replace the formatter PCB. Replace the engine controller. Memory overflow/memory full (20) 30016 The printer memory is full. Press Go to resume printing. If you lose some data, try to free some printer memory by removing any unnecessary fonts, macros, or any other data currently in the printer memory. If you continue to lose data, you might need to add more printer memory. For a temporary solution, simplify the image or print at a lower resolution.