4 Introduction General Information load of not less than 10A (>2000W). Make sure to ask a professional electrician to install the power charging circuit for you. The power charging circuit installation must be properly grounded, and the main switch as well as the leakage protection device must be installed. 6. The vehicle will prioritize power 1. This vehicle is an electric battery- consumption from the main battery after entering the "READY" condition (the "READY" light is on), and you can turn on lights and A/C for an extended period. The Power Battery will start charging the 12V battery.
powered vehicle (Battery Electric Vehicle / BEV), and some of its operations and characteristics differ from traditional fuel-powered vehicles. Therefore, please read the Manual carefully before using this vehicle. 4. Orange-colored cables in this vehicle are high-voltage cables. Do not touch them. Pay special attention to the warning signs installed on the high-voltage component coverings. 7. When we identify abnormal data 2. This vehicle is powered by electric from your vehicle on the back-end server, our service personnel may contact you. We need your support and cooperation to avoid potential hazards. energy.
The vehicle is equipped with two batteries, one of which is the Power Battery located under the frame to provide power to the vehicle, and the other is a common 12V car battery located in the front compartment to provide power for instruments, lights, and relevant modules. 5. The vehicle will consume power from the 12V battery before entering the "READY" condition (the "READY" light is not illuminated). Therefore, do not turn on lights, audio systems, A/C, etc., for an extended period to avoid the vehicle being unable to start due to the 12V battery running out of power. If the 12V battery is low, recharge it first. 8.
Do not use tools with fake grounds that can pose a potential electrical shock hazard during charging. 3. The Power Battery must be charged with 220V alternating current (e.g. common household power supply). When charging the Power Battery with household alternating current, ensure that all cables, ports, and power charging path plugs have a