1. Connection Procedure for Remote Access 6.3.5. Connection Settings with the Controller Set the IP address of DEV ports on the SiteManager. Startup Guide – Remote Access - RT1 Series - P151-E1-02 31 2 On the screen for WiFi connection settings, set the following items of connection information. Click Save. ・WiFi SSID ・WiFi Key *Check the connection information for the WiFi environment you use, and then set the items above. After completing the settings, click Continue Setup. The SETUP screen in step 1 appears again. 3 Check that SiteManager is connected to the internet and, with the LEDs on SiteManager, that communication with GateManager is established. ・STATUS: On GREEN ・UPLINK2:
On GREEN 1 Set the IP address of DEV1– DEV3 ports to connect Controller by following the steps below. Click Edit for 4. DEV port.