Overview 3. Overview This guide describes the connection procedure for remote access from Sysmac Studio on a personal computer to an NJ/NX-series Machine Automation Controller (hereinafter referred to as the "Controller") in a remote location, by using RT SiteManager, GateManager and LinkManager. Refer to Section 5 Remote Access Settings and Section 6 Connection Procedure for Remote Access to understand setting methods and key points so that you can build a secure remote access environment via the internet. The SiteManager is a remote access gateway (hardware) that is installed in the field.
The LinkManager is a communication software for remote access from your personal computer in a remote location to a device placed in the field. The GateManager is a cloud service (M2M server) to remotely connect the SiteManager and the LinkManager via the internet. GateManager Internet Controller Personal computer (LinkManager, Sysmac Studio) SiteManager The purpose of this guide is to explain the settings and procedures required for online connections via the internet between Sysmac Studio on a personal computer and the Controller in a remote location. This is not to explain control commands or remote monitoring performed using remote access to control devices connected to the Controller.
When you set up an on-site system, refer to this guide and with safety in mind, make sure an online connection can be made between Sysmac Studio on your personal computer and the Controller in a remote location, with no control devices connected to the Controller. 4 Startup Guide – Remote Access - RT1 Series - P151-E1-02