7 ． EtherNet/IP Connection Procedure 7.3. Controller Setup Set up Controller. 7.3.1. IP Address Settings Start Sysmac Studio and set the IP addresses of Controller. Install Sysmac Studio and the USB driver on Personal computer beforehand. 21 1 Connect the LAN cable to the Personal CPU Unit End Cover built-in EtherNet/IP port computer Controller (PORT1) on Controller, and Switching hub connect a USB cable to the USB cable peripheral (USB) port. Robot As shown in 5.2. Device Power Supply Unit LAN cable Controller Configuration, connect Personal computer and Switching hub to Controller. 2 Start Sysmac Studio.
*If the User Account Control Dialog Box is displayed at start, make a selection to start Sysmac Studio. 3 Sysmac Studio starts. Click New Project.