9 ． Appendix: Procedure Using the Project File 9. Appendix: Procedure Using the Project File This section describes the procedure in which you use the following project file. Obtain a latest project file from OMRON. The project file includes the setting contents described in 7.3. Controller Setup . 9.1. Work Flow Take the following steps to make the EtherNet/IP tag data link settings using the project file. Refer back to each of the following procedures for details except for 9.2.1. Importing the Project File marked with a red square. 43 Name File name Version OMRON ePLCIO EIP EV100.csm2 _ _ _ 7.2. Robot Controller Setup Set up Robot Controller. ↓ 9.2.
Controller Setup Set up Controller using the project file. ↓ 7.3.1. IP Address Settings Start Sysmac Studio and set the IP address of Controller. ↓ 9.2.1. Importing the Project File Import the project file to Sysmac Studio. ↓ 7.3.6. Transferring the Project Data Connect online and transfer the connection settings and the project data to Controller. ↓ 7.4. EtherNet/IP Communication Status Check Confirm that the EtherNet/IP tag data links are operated normally.