Attaching the pedestal to TV Assembling the pedestal Fix securely with assembly screws A (Total 4 screws). Tighten screws firmly. A A Accessories Assembly screws (4 of each) Pole A XYN5+F20FN size (M5 Ч 20) (Silver) Base Front B (Image: TBL5ZX0032) Set-up THEL088N (for 42”) THEL087N (for 46”, 50”) size (M5 Ч 25) (Black) Bracket (1) Carry out work on a horizontal and level surface. Tighten assembly screws B (total 4 screws) loosely at first, then tighten them firmly to fix securely. Bottom view B Rear side Arrow mark Base (1) Arrow mark Hole for pedestal installation Pole Base (Image:
TC-P50S30) Removing the pedestal from the TV Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV. Remove the assembly screws B from the TV. Pull out the TV from the pedestal. Remove the assembly screws A from the pole. Warning Do not disassemble or modify the pedestal. Otherwise the TV may fall over and become damaged, and personal injury may result. Caution Do not use any pedestal other than that provided with this TV. Otherwise the TV may fall over and become damaged, and personal injury may result. Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately. During set-up, make sure that all screws are securely tightened. If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the TV, and it might fall over and become damaged, and personal injury may result. When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. 8 Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.