Quick Guide Inserting the battery Install the battery by inserting it in the direction shown in the figure. Inserting/removing an SD card A Insert the battery until it clicks and locks. Charging the battery Access lamp [ACCESS] A When this unit is accessing the SD card, the access lamp lights up. 1) Open the LCD monitor. Check that the access lamp has gone off. 2) Open the SD card/terminal cover and insert (remove) the SD card into (from) the card slot. Face the label side B in the direction shown in the illustration and press it straight in as far as it will go. Press the center of the SD card and then pull it straight out. 3) Securely close the SD card/terminal cover.
Securely close it until it clicks. A DC input terminal 1 Connect the AC adaptor to the DC input terminal. 2 Connect the AC cable to the AC adaptor, then the AC outlet. The status indicator will flash red at an interval of 2 seconds, indicating that charging has begun. It will turn off when the charging is completed. 12 VQT3K35