Connecting a device Preparation If this system is connected to a Bluetooth ® device, disconnect it ( ~ 13). 1 Press [ ]. “BLUETOOTH READY” is shown. 2 Select “SC-PM270” from the Bluetooth ® menu of the device. The name of the connected device is shown for a few seconds. 3 Start playback on the device. Note: A device must be paired to connect. This system can only connect to one device at a time. When “BLUETOOTH” is selected as the source, this system will automatically try to connect to the last connected device. (“LINKING” is shown during this process.) Disconnecting a device While a Bluetooth ® device is connected 1 Press [PLAY MENU] repeatedly to select “DISCONNECT?”.
2 Press [ R , T ] to select “OK? YES” and then press [OK]. “BLUETOOTH READY” is shown. To cancel, select “OK? NO”. Using the main unit Press and hold [– PAIRING] until “PAIRING” is shown. Note: A device is disconnected when you: Select a different source. Move the device out of the maximum range. Disable the Bluetooth ® transmission of the device. Turn off the system or the device. TQBM0945 13