EN FUNCTIONAL OVERVIEW Front Panel 2 1 5 6* 7 8 10 3* 4 9 * The unit can also be turned on by pressing these buttons. 11 12 1. Q (standby/on) button Press to turn on the unit, or to turn the unit into the standby mode. (To completely turn off the unit, you must unplug the AC power cord.) Press and hold for 10 seconds to shut down the unit. This button lights up in red when the unit is in standby mode and turns off when the power is on. 2. Disc tray Place a disc after opening the disc tray. 3. A (open/close) button* Press to open or close the disc tray. 4. H / G (previous / next) button Press to skip to the previous or next title / chapter / track. 5. C (stop) button Press to stop playback.
6. B (play) button* Press to start or resume playback. 7. SOURCE button Press to switch the active source mode. 8. Infrared sensor window Receive signals from your remote control so that you can control the unit from a distance. 9. Display Refer to “Front Panel Display” on page 14. 10. VOLUME jog Rotate to adjust the volume. 11. SD CARD slot Insert an SD Memory Card and play back the contents in it. 12. MP3 LINK jack Phono input for connecting to the headphone jack on your portable audio player. Introduction Connections Basic Setup Playback Others Function Setup Other Functions Note This unit will be turned into the standby mode automatically after 25 minutes of no action.
Rear Panel 1 8 7 4 6 3 2 5 SPEAKERS 4 LAN HDMI OUT COMPONENT VIDEO OUT AUDIO IN AUX 1 AUX 2 FM ANT 75 DIGITAL AUDIO IN Y Pr AC 120V 60Hz SUB- WOOFER FRONT CENTER REAR FRONT COAXIAL VIDEO OUT Pb 9 1. AC power cord Connect to a standard AC outlet to supply power to this unit. Unplug this cord from the AC outlet to completely turn off the unit. 2. 5.1ch Audio Out jacks (SPEAKERS (4 Ω )) Use to connect supplied 5.1ch speakers. 3. LAN terminal Use to connect a telecommunications equipment with LAN cable. 4. HDMI OUT jack Use to connect to a display with an HDMI compatible port with an HDMI cable. 5.
AUDIO IN (AUX1 / AUX2) jacks Use to connect an other device with audio out jack with an RCA audio cable. 6. FM ANT 75 Ω jack Use to connect the supplied FM wire antenna. 7. DIGITAL AUDIO IN (COAXIAL) jack Use to connect an other device with a digital audio coaxial output jack with a digital audio coaxial cable. 8. COMPONENT VIDEO OUT jacks Use to connect a TV monitor with component video inputs with an RCA component video cable. 9. VIDEO OUT jack Use to connect a TV monitor, an AV receiver / amplifier or other device with an RCA video cable. Note Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.
This unit does not have the RF modulator. 11 EN