Getting Started English Step 1: Inserting batteries into the remote control Step 2: Setting the TV IMPORTANT! Make sure you have completed all the necessary connections. (See page 11 “Connecting TV”). 3 1 1 Press SOURCE control until “ DISC appears on the display panel (or press DISC on the remote). 2 2 Turn on the TV and set to the correct video-in channel. You should see the blue Philips DVD background screen on the TV. 1 Open the battery compartment. 2 Insert two batteries type R06 or AA, following the indications (+-) inside the compartment. 3 Close the cover. 3 Usually this channel is between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO.
See your TV manual for more details. Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In Or, the TV remote control may have a button or switch that chooses different Or, set the TV to channel 3 or 4 if you are using an RF modulator. Using the remote control to operate the system CAUTION! Remove batteries if they are exhausted or if the remote is not to be used for a long time. Do not use old and new or different types of batteries in combination. Batteries contain chemical substances, so they should be disposed of properly.
16 001-041-LX36-22-Eng 21/08/2003, 9:44 AM 16 3139 115 22612 1 Aim the remote cont directly at the remote rol OPEN/CLOSE PLAY/PA PREV USE chan ➜O butt sensor (iR) on the fro nt IR SOURCE wish one e ed