» Display “ CALIBRATE – PRESS PLAY Setup Menu IR out Mic in Mic in Insert Mic The unit allows you to configure advanced settings to provide you with an even better experience. 1 Press the (MENU) button on the remote control to open the menu. 2 Select the content with / (Down / Up) on the remote controller. 3 Press (Enter) to confirm your selection. 4 Change the initial values for each of the settings with the cursors / (Left / Right). 5 Press (Enter) to confirm your selection. To return to the previous screen/ exit the settings, press (Exit). If no button is pressed within 10 seconds, the system will automatically exit the menu.
Audio settings Set calibration Point the microphone up and place it where the viewer's head is when seated facing the screen. (Don't place it too low, or too close to the speakers, and it shouldn't be placed upside down on the headrest of a sofa (the fabric absorbs some sound waves and can distort the measurements). 3 Upon press to start calibration, test tones will be played according to different configurations. Display Description » Once calibration is done, display DONE – REMOVE MIC 4 When a full auto calibration setup process has completed, the calibrated parameters can be enabled/disabled via menu. ON: The last calibrated parameters shall be applied OFF:
All calibrated parameters shall be disabled. The last parameters shall be remembered. Exit Auto Calibration Setup Auto calibration setup can be cancelled via 2 ways: Unplug MIC from MIC IN. While MIC is still inserted, Press (Exit) on the remote control. Stop playing back test tones for each channel. 22 EN FL XX Front Left Speaker FR XX Front Right Speaker XX Subwoofer CT XX Center Speaker L XX Side Left Speaker R XX Side Right Speaker DI Set display and light ring brightness DI P XX Auto turn off display LIGHT ATMOS Light ring control TNBY XX Auto-standby ON/OFF BT PAIR Start Bluetooth pairing (Only in BT mode) UB PAIR Start Subwoofer pairing UPGRADE Update firmware via USB