Switch on and Set Up the TV Press Н or Ж 5 times to select the side of the pictures that is the most pleasing to you. then press OK . Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press . on the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Left side Right side Press OK to fi nish [Settings assistant] . Settings assistant Settings assistant Follow the on-screen instructions to select your language and complete your TV setup. Installation takes approximately 10 minutes. You have set up your viewing preferences.
Press Н or Ж to select the desired mode for energy saving, then press OK . OK Exit Store Back BACK MENU Finish the Setup. Initial Setup Initial Setup Select “Retail” or “Home” for your location. Retail Home Select OK OK SETUP Exit Select [Retail] if you want backlight to be brighter. Select [Retail] , the unit will be set up with predefi ned setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR ® qualifi cation. Select [Home] , the unit is set to maximize the energy effi ciency for home setting and it can be adjusted through a choice of picture and sound quality according to your preference.
Select [Home] to reduce the power consumption. Press OK to begin [Settings Assistant] . Settings assistant Settings assistant Settings assistant helps you customize picture settings. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/ Right keys. OK Exit Next Back BACK MENU 12 EN Initial Setup Select your menu language. Seleccione el idioma para el menú. Sélectionnez la langue du menu. English Español Français MENU Select OK OK Skip 1/5 Select the picture setting that you prefer. Select OK Next BACK MENU Back Exit Note • If you connect the cable system directly, contact the CATV installer.
• If you press . or MENU during autoprogram, this setting will be canceled. • The initial autoprogram function can be executed for either [Antenna] or [Cable] only once. When you change the connection (Antenna/Cable), set autoprogram again. (Refer to page 24.) • If there is no signal input from the antenna terminal and no operation for several seconds after you turn on the TV, [Helpful Hints] appears. Follow the instructions listed on the TV screen.