7 Install channels Autoprogram Before you install channels, ensure that you are registered with your cable TV provider and that your equipment is correctly connected. 1 Press MENU on the remote control and select [Setup] > [Autoprogram] . The fi rst time you set up your TV, you are prompted to select a menu language and to install TV and digital radio channels (if available). This chapter provides instructions on how to reinstall and fi ne-tune channels. Selecting your menu language Picture Autoprogram 1 Press MENU on the remote control and select [Language] . Sound Channel List Setup Features Add Channels Antenna Language Picture Sound Select your menu language.
English USB Setup Seleccione el idioma para el menъ. Features Language Espacol 2 Press OK to start the installation. USB Sйlectionnez la langue du menu. Franзais If you run [Autoprogram] when you have locked channels, a message appears asking to enter your PIN . Enter your PIN in order to complete the installation. If you have forgotten your PIN, reset it as described in Changing your PIN on page 18. 3 Select [Antenna] or [Cable] and press OK . When [Antenna] is selected, the TV detects antenna signals. It searches for NTSC and ATSC channels available in your area. When [Cable] is selected, the TV detects signals supplied by cable.
It searches for NTSC, ATSC, and QAM modulated channels available in your area. 2 Select a language and press OK to confi rm your choice. 3 Press MENU to exit. Picture Back Sound Setup Autoprogram will rescan all channels. Auto programming may take more than 20 minutes to complete. Antenna Cable Features Select your signal source. Language USB Antenna Cable Or When autoprogramming is complete, the lowest memorized channel will be displayed. 4 Follow the on-screen instructions to complete the installation. 24 EN ANT.IN