Disassembly Step Each step in the removal process outlines the following: Component: The component name is always in bold. Part Number: The part number for the component being removed. Reference Designator: A visual reference to the component to remove. Required Tool: Lists the tool needed to perform the listed action Sometimes a component may be listed in a procedure without a part number. For example, the technician may be directed to remove the connector labeled main control board . In this case there will not be an accompanying reference designator or illustration. Items such as connectors (and some wire harnesses) are referenced as plugs (i.e.
P2) and do not have a part number other than that of the physical connector. These types of items are simply referred to by the label near the connector end. Component to be removed Component part number Reference designator Remove two strikeplates (p/n 0702-001-323) (BN) on the bottom of front cover assembly using 3/16” allen wrench. Required Tool D ISASSEMBLY S TEP vii 0000026959, Rev. C Effective Date: Dec 16, 2014 3:43:21 PM Print Date: Dec 16, 2014 04:03:57 PM