PREPARATION & CONNECTION 1. Turn the ignition off. 2. Locate the vehicle’s DLC port. 3. Connect one end of the diagnostic cable to the DB-15 port on the Phoenix Nano and tighten the captive screws. 4. Plug the adaptor to vehicle's DLC connector. 5. Turn the ignition on. The engine can be off or running. 6. Hold the power button for 3 seconds to turn the TOPDON Phoenix Nano on. The tablet will start initializing and enter the home interface. *Note: Do not connect or disconnect any test equipment with the ignition on or engine running. 7. Connect Wi-Fi Tap "Settings" -> "Network & internet" -> "Wi-Fi." The system will 6