HP-335 Nov. 1998 NOTE : Basically, this mode will be bypassed and jump to the MODEL NAME mode. However, with early productions, the BUILD number will be displayed to the 7-SEG LED. 4. Effect Sound, Speaker and Panning Check (When you want to proceed on to the next stage during this test, press [Function] button.) Press [Function] to go on the TEST MODE. When you get into this mode, 7-SEG LED displays ''Pan''. * MODEL NAME Press following buttons and confirm the Effect sound and other settings. ''335'' shall be displayed to the 7-SEG LED. Press [Function] to go on the TEST MODE. BUTTON PANNING TONE EFFECTS [piano] Center Piano Non 3.
Buttons and LEDs Check [E.piano] Center Piano Chorus All of the LEDs on the panel shall illuminate. [Harpsi] Center Piano Reverb [Vibes] Center Piano Resonance NOTE: When you press [Function] button at the start it will move to the next mode and this mode will be bypassed. When you execute the check of Buttons and LEDs, do not press [Function] button first. [Organ] Left 440Hz Sine Wave Non [Strings] Right 440Hz Square Wave Non [Choir] Center 440Hz Sine Wave Non * Press the following buttons. Confirm the sound output and the LED becomes non-illuminated. Press [Function] to go on the TEST MODE. 5.
Pedal Check [piano] [E.piano] [Harpsi] [Vibes] [Organ] [Strings] [Choir] [GS Tones] [Reverb] [Chorul] [Pianist] [Split] [Transpose] [Track R] [Track 1] [Track 2] [Play] [Rec] [Function] (When you want to proceed on to the next stage during this test, press [Function] button.) When you get into this mode, 7-SEG LED displays . * Press the following button twice. Confirm the sound output and the LED alternately changes from ''Orange'' ''Green'' non-illuminated. [Key Touch] Depress each [Soft], [Sostenuto] and [Damper] pedals one by one slowly. The output sound (Tone) should be changed related to the depressed depth of the pedal and also the value should appear on the 7- SEG LED.
The value may change from 0 to 9 and at the full depressed position, a Metronome sound could be heard. * Press the following button twice. Confirm the sound output and the LED at the left side of the 7-SEG LED alternately changes from ''Orange'' ''Green'' non-illuminated. [Metronome] The correspondence between the display and the Pedals are as follows. * Press the following buttons. Confirm the sound output and related LEDs at the right side of the 7-SEG LED becomes non-illuminated. [Song] [Beat] [Tempo] 7-SEG LED display Checked Pedal 3rd figure of the 7-SEG LED : Soft Pedal * Press the following button. Confirm the sound output and left two figures of the 7-SEG LED become non-illuminated.
2nd figure of the 7-SEG LED : Sostenuto Pedal [Value +] * Press the following button. Confirm the sound output and right one figure of the 7-SEG LED becomes non-illuminated. 1st figure of the 7-SEG LED : Damper Pedal When you finish checking and there is no malfunction with all of the three Pedals, it automatically moves to the next Test mode. [Value -] When you finish this Buttons and LEDs check, it automatically moves to the next Test item. In the other words, unless you perform all of the buttons and LEDs check, it cannot proceed on to the next mode. 13