HP-535 Nov. 1998 3. Fitting the Rear Board 5. Connecting the Pedal and Power Cords Ў Position the Rear Board so the side on which the wood- grain is visible faces the same direction as the three pedals, as shown in the illustration. Ў Connect the pedal cord to the Pedal jack on the rear of the piano. Ў Connect the power cord to the power inlet on the piano, then plug the other end into a wall socket. Wood grain side Ў Using screws “a,” fasten the Rear Board to the Side Boards at right and left (two screws each at right and left). Then, fasten the Rear Board to the Pedal Board with screws “b” (four places). Observe the direction shown by the arrow in the illustration. 6.
Adjusting the Adjuster Screw a Ў Lower the adjuster at the bottom of the pedal board (by rotating it), so that the pedal board touches the floor. If you have the piano placed on a carpet, lower it until it pushes into the carpet. Screw b 4. Installing the Piano on the Stand Ў Align the joint screws (one each at right and left) on the bottom of the piano with the openings in the metal fittings on the side board, then slide the piano forward until the screws are held in place. Ў Fasten the piano to the stand with the screw “c” (M5 X 20 mm) (one each for the right and left). When Moving the Piano Disconnect the power cord and raise the stand’s adjuster.
Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught. * When handling the piano, firmly grasp it at the front and back. Be careful, so you do not get your fingers pinched. 13