oyster. ‘roubles and Events If the system does not appear to be operating (i.e. the display is blank) or if the system is causing any problems with your phone system, then call your installing company if any of the tu.uuwing events occur, they should be automatically reported to the central station by the system. All touble conditions are displayed on your control AC POWER FAILURE The electrical power has been out for the time specified in the front of this manual (the system is running off of its battery). DEVICE LOW BATT A pendant’s battery needs to be replaced. Station(s) until you acknowledge them and the trouble condition is cleared.
You can acknowledge a trouble disconnected or not functioning. for repairs. (The phone number is listed in the front of this manual.) condition by pressing the “Clear” key. Several conditions may Clear themselves automatically, such as AC Power Failure and Panel Battery Low. Other conditions may be cleared by pressing the “Clear” key a second time. If any of the following events occur, they should be automatically reported to the central station by the system. In some cases, the trouble condition may prevent the events from being reported. You should call your installing company for repairs. FAILED TO COMM The system was unable to reach the central station by telephone to report an event.
MEMORY FAILURE ‘The system’s memory has been cormpted. NO COMMUNICATION FROM CONTROL system has had a catastrophic failure. The NO KPD RESPONSE A control station is PANEL BATT: LOW The system’s backup battery needs to be replaced. POINT LOW BATT A wireless point’s battery needs to be replaced. PT NOT REPORTING A wireless point failed to report in on time. RF JAMMING The system is experiencing radio interference. TAMPERED POINT A hardwired zone or wireless point was tampered with while it was armed. TROUBLED POINT A hardwired zone or wireless point was tampered with while it was disarmed. LOG NEARLY FULL Indicates that your Event Log has reached the 80% full point.
The installing company is responsible for emptying your Event Log. Just press “Clear” to acknowledge the event.