Radio parameters 3.3.2 Functional Descriptions Note: To toggle between the Plug and Play and RFID reader charging modes, touch the supplied charging card on the charger for more than 5 seconds (until a beep sound is heard). After the RFID reader mode is enabled, touch the card on the charger to start / stop charging (charging plug should be connected before you can start charging). 11 Item Operating Frequency Range Maximum Transmitting power Antenna Gain WIFI 2400-2483.5MHz +3dBi Bluetooth 2400-2483.5MHz +2dBi Item Operating Frequency Range Transmitting Field Strength Antenna Gain RFID 13.56MHz +0dBi Charging Mode Mode 3 Charging Control Local:
Plug and play RFID reader mode Indicator Lights Charging status indicator Communication Interface Ethernet (RJ45 interface) Supports OCPP 1.6J Protocol (Optional) Communication Interface (Optional) RS-485 with special communication protocols Safety Protection Surge protection, over temperature, over / under voltage, over current, LN reverse polarity, leakage, ground protection RCD Built-in RAMU, Type A IΔn=30mA + IΔdc=6mA (Conforms to IEC 62955, IEC 61008)