PROBLEM: It keeps giving me an error tone and it doesn’t do what I want. SOLUTION: Press to reset the system. Then repeat your security code and command string. More than likely you just wound up out of synch with the DCI2 so you are not entering the data it is looking for. When in doubt, press the button to reset the command entry algorithm back to a known state. PROBLEM: I forgot my security code! SOLUTION: No problem, just follow the instructions in the Using Yout DCI2 DTMF Controller Interface section to program a new one. PROBLEM: I’m trying to feed audio into the J6 input but it doesn’t work. SOLUTION:
Depending on your audio level, you may need to replace R10, a 10K ohm resistor (brown-black-orange), with a jumper wire to connect it di- rectly to ground. This will increase your audio levels if needed. DCI2 31