Maintenance Key to maintenance intervals – BMW Inspection at 1,000 km (600 miles) I – BMW Service every 10,000 km (6,000 miles) II – BMW Inspection, every 20,000 km (12,000 miles) III – BMW Annual Service IV Reading out MoDiTeC fault memory 11 4 650 (Inspections I, II, III and IV) C000030 • Remove the seat. • Connect the BMW MoDiTeC to the diagnosis connector. • Read out the fault memory. • Perform all requisite repair work. • Remove oil drain plug and drain off oil. • Reinstall the oil drain plug with a new sealing ring. • Use oil filter wrench, BMW No. 11 4 650 , to re- move the oil filter. • Coat sealing ring on new oil filter element with oil and install filter.
• Refill with oil to correct level. • Install the screw plug. e Caution: Never top up the engine-oil level past the “MAX” mark. Changing engine oil, replacing oil filter element (Inspections I, II, III and IV) L Note: If the motorcycle is ridden only for short distances or outside temperatures are below 0°C (32°F) change the oil and replace the oil filter element every 3 months, or not later than every 3,000 km (1,800 miles). X Tightening torque: Oil filter......................................................... 11 Nm Oil drain plug................................................ 32 Nm • Change the oil at operating temperature. Engine oil quantities:
With oil filter change................................................ ..................... 3.75 l (6.6 Imp. pints/3.96 US quarts) Without oil filter change........................................... ..................... 3.50 l (6.2 Imp. pints/3.69 US quarts) Quantity of oil between MIN and MAX marks ............................................... .......................0.50 l (0.88 Imp. pint/0.52 US quart) MAX MIN Engine oil grade: Brand-name HD oil for spark-ignition engines, API classifications SF, SG, SH; combination with CD or CE specification. Brand-name HD oil of CCMC classification G4, G5; amendment PD2 is permissible. S000040 • Remove screw plug. 00.22