Checking brake system for correct operation and freedom from leaks; repairing/replacing if necessary Rear brake • The motorcycle must be upright. • L commodate lining wear. If the level drops below the MIN mark, this indicates some other fault. Required level Brake pads new: ............................................. MAX Brake pads worn: not less than........................ MIN Front brake Brake fluid grade .........................................DOT 4 • Place the motorcycle on its centre stand. MIN R21000060 • Turn the handlebars to the right. • Check that the front wheel is on the ground. Required level with new brake pads: (Initial fill quantity) ..
make sure that no bubbles are visible in the sight glass • Handlebar centred. • Check that the front wheel is on the ground. Minimum fluid level Brake pads worn: not less than............................... ........................................... half way up sight glass Brake fluid grade .........................................DOT 4 00.28 ection III) heck brake system for leaks. cking brake fluid level ections II and III) Note: olume of the brake fluid (MIN/MAX) is sufficient ing thicknesses from new to the wear limit. ot normally necessary to top up the fluid to ac- MAX MIN R21000120 R21000120