• Disconnect the brake bleeding device from the bleed screw. • Reinstall socket-head grub screw (2) in the filler adapter. Checking tightness of rear wheel studs (Inspection I) e Caution: The motorcycle is not permitted on the road without the grub screw in place and secure in the filler adapter. • Tighten the rear wheel studs with a torque wrench. X Tightening torque: Rear wheel studs ....................................... 105 Nm • Correct the fluid level. • Reinstall the reservoir lid with rubber diaphragm in position. • Tighten the reservoir cover carefully and without using force. • Align the clutch fitting with the mark on the han- dlebar.
• Resecure the handlebar in the correct position (punch marks aligned). • Recheck the fluid level. X Tightening torque: Grub screw in filler adapter .......................... 10 Nm Handlebar to fork bridge .............................. 21 Nm Checking rear wheel bearing play by tilting wheel (Inspection III) • Tilt the rear wheel to and fro across its axle. • If play is detected, fit new shims to rear wheel drive or replace bearings. Checking swinging arm bearings, adjusting if necessary (Inspections I and III) Consumables Brake fluid.....................................................DOT 4 • Grip rear tyre and try to move it sideways, brac- ing against the frame. 00.35