BMW Motorrad Maintenance schedule C1, C1 200 UX-VS-2, 10.2001 BMW recommends Castrol Customer Licence No. Mileage Job Order No. Date Mechanic's signature BMW Inspection at 10,00 km/600 miles BMW Maintenance Service every 7,500 km/4,500 miles BMW Inspection every 15,000 km/ 9,000 miles BMW Annual Service MoDiTeC/DIS plus, read fault code memory Change the engine oil while at regular operating temperature and replace the oil filter element If the vehicle is ridden for short distances only or at outside temperatures below 0° C (32° F):
every 3 months or after every 3,000 km (1,800 miles) at the latest Clean oil strainer and magnetic plug Change transmission fluid every 30,000 km/18,000 miles or 3 years*) Inspect coolant level, top up if necessary, inspect hoses for damage, chafing points Change the coolant every 2 years*) Check valve clearances and adjust if necessary *) Replacing spark plug Replace air filter element shorten change interval if severely dirty or dusty Drain condensate drain hose from air manifold Brake hoses and connections:
check condition and routing Check operation of brake system and check for leaks; repair/replace as necessary*) Inspect brake fluid level at front/rear Examine brake pads and discs for wear, renew if necessary*) Renew brake fluid at least once a year Replace variator belt Check clutch liner, replace if necessary*) Cleaning mesh filter of variator Grease driving variator (greased version) Check and clean driving variator (ungreased version, replace variator if necessary) Replace complete driving variator every 22,500 km/14,000 miles, greased version only Check wheel bearings for play; replace if necessary*) Checking that leading-link mounts are free of play Battery:
check battery acid level, if necessary add distilled water Clean and grease the battery terminals, if necessary Check freedom of movement of Bowden cables, check for abrasion and damage Easy-lift mechanism: – Check operation of mechanism and check freedom of movement – Inspect Bowden cables for damage and signs of wear and chafing, ensuring that mechanism moves freely without binding; check free travel and adjust as required *) Check windscreen washer system; adjust nozzles if necessary and top up washer fluid in reservoir Check windscreen wiper; replace wiper blade if necessary *) Safety elements:
check cable for release, belt buckles, belt strap, inertia reels, and belt locks Check crash element for damage Inspect shoulder bar for damage, replace deformation element if necessary*) Replace fuel filter every 37,500 km/22,500 miles Only ABS: Replace seal in brake master cylinder every 30,000 km/18,000 miles*) Check tightness of bolts and nuts at engine mountings and quick-release axles Final inspection with road safety and functional check:
– Clutch engagement, steering, front and rear brake – Condition of tyres and wheels, tyre inflation pressure – Lights and signalling equipment, telltale and warning lights, instruments – If necessary, test ride *) Write up on separate invoice; Not part of standard service procedure