Contents - Maintenance Page Changing brake fluid and bleeding brake system ...................................................30 Change the brake fluid annually (Inspection IV) [ABS Inspections II and III] Bleeding front brake circuit/changing brake fluid ..........................................................30 Additional information for [ABS] Bleeding rear brake circuit/changing brake fluid ............................................................32 Checking clutch fluid level ....................................................................................................33 (Inspections I, II and III) Changing the clutch fluid .......................................................................................................33 (Inspections III and IV) Every 40 000 km (24 000 miles) or every 2 years at the latest Checking tightness of rear wheel studs ........................................................................34 (Inspection I) Checking rear wheel bearing play by tilting wheel .................................................34 (Inspection III) Checking swinging arm bearings, adjusting if necessary ...................................34 (Inspections I and III) Greasing the side stand pivot ..............................................................................................35 (Inspections I, II and III) Checking function of side stand switch ........................................................................35 (Inspections I, II, III and IV) Checking/replacing spark plugs ........................................................................................35 (Inspection II) check/(Inspection III) replace Tightening cylinder heads .....................................................................................................36 (Inspection I) Checking/adjusting valve clearances ......................................................................................................................................36 (Inspections I, II and III) Checking throttle cable for ease of movement, abrasion and kinks; repla- cing if necessary Checking throttle-cable play Checking/adjusting idle speed and throttle-valve synchronisation ...............37 (Inspections I, II, III and IV) Final inspection with road safety and functional check .......................................38 (Inspections I, II, III and IV) Road safety check Roadworthiness check 00.4