B BMW AG Motorcycle Division Service Data R 1100 RT/R 1100 RS/R 1100 GS/R 1100 R/R 850 R Order No. 01 71 9 799 171 UX-VS-1, 7/95 Printed in Germany Designation Data Measuring unit or specification Oilcapacities Engine (incl. filter) Engine (without filter renewal) Gearbox Rear wheel drive 3.75 5.50 fresh fill 1.0 change 0.8 fresh fill 0.25 change 0.23 litre litre [SI 11 048 90] Brand-name HD oil for petrol engines of API classi- fication SE, SF, SG; combination with CC or CD specification litre litre litre litre Valve clearance measured cold, i.e. at max.
35 °C E 0.15 / A 0.30 mm Ignition Static ignition disconnect at 6° b TDC Spark plugs Electrode gap limit of wear Bosch FR5DTC 0.8 1.0 mm mm Engine idle speed 1000 +150 1/min CO value (without catalytic converter) 1.5 ±0.5 Vol % Cable adjustment for increased cold starting speed (without cable junction) (with cable junction) throttle (without cable junction) gas cable (one piece) connecting cable throttle (with cable junction) gas cable (one piece) junction cable mm play mm play mm play Clutch cable adjustment wire cable at handle bar lever at lever 12.0 7.0 mm thread mm play Tyre pressure depending on load and speed front: 2.2 – 2.5 rear: 2.5 – 2.9 bar bar Tightening torques:
Oilfilter Engine oil drain plug Gearbox oil drain plug Rear wheel drive oil drain plug Locknut valve adjustment Cylinder head cover Generator to bracket Tension multiple ripped belt (Poly-V) Spark plugs Fuel tank to rear frame Fuel pump to tank Adjustable handle bars Quick release axle thread (axial) Quick release axle clamp Brake caliper Bearing bolt swingarm to gearbox/rear axle Idler bearing pin on swinging arm on gearbox/rear wheel drive Locknut Rear wheel retaining studs Tube clips to air intake pipe Screw connect.
spring strut on control arm (RS with slide bearing) Tighten cylinder head – M 10 screw 11 32 23 23 8 8 20 8 20 22 6 20 30 22 front / rear 40 150 (Loctite 2701) 7 (Loctite 2701) 105 (Loctite 2701) 105 2 43 Thighten 20 180 40 Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm Nm (clean thread) Nm (clean thread) Nm (clean thread) Nm Nm Nm (8.8 screw) Nm ° Torsion angle Nm