Renewing brake pads Front brake Renewing brake pads Rear brake C000100 C000140 • Detach/remove brake caliper from mounting (ar- row). • Loosen the rear wheel. • Unfasten/remove brake caliper. • Remove circlip (arrow) at retaining pin. • Drive the retaining pin out towards the wheel side. • Remove brake pads. • Install by following the above work instructions in the reverse order. • Before installing the brake caliper, depress the piston fully. X Tightening torque: Brake caliper to rear wheel drive .................. 40 Nm Screw the rear wheel studs in handtight, then tighten them in a crosswise pattern. Initial tightening............................................
50 Nm Final tightening........................................... 105 Nm 1 2 C000230 • Remove the split-pin keeper (1) from the retain- ing pin (2). • Drive out retaining pin (2). • Remove brake pads by pulling downwards. • Install by following the above work instructions in the reverse order. • Before installing the brake caliper, force the pis- tons fully back with resetting tool, BMW No. 34 1 500 . X Tightening torque: Brake caliper at fork slider tube.................... 40 Nm 00.20