RIEVTECH STUDIO SOFTWARE MANUAL As shown as the figure below, you can modify the color, the width and type of the meter scale line after the “ Display Scale ” is checked. Ш Line Ш Scale You can set the “ Main Scale Division Number ” , the “ Main Scale Length ” and the “ Sub Scale Length ” here. The Location of the scale can be set “ Inside ” , “ Outside ” and “ Center ” , as shown as below. The “ Sub Scale Division Number ” and the “ Axis ” are checked by default. The default sub scale division number is 2. If the “ Sub Scale Division Number ” and the “ Axis ” are unchecked, that means the sub scale and axis are not displayed.
If the “ Mark ” is not checked, the meter will not display the scale value. After the “ Mark ” is checked, you can set the number of the integer digits and the decimal digits of the scale value and also can set the font styles of scale value. If you select the "Reverse scale order", then the maximum value and the minimum value will switch their positions. 229